HOME COMMUNITY FORUM WIKI BLOG LEARN
0

$USD

$USD
TUTORIALS DFRobotEnglish

Tips for changing the sensor cable pin mapping

DFRobot Feb 25 2013 4183
Sometimes the pin mapping of my sensor cable is not compatible with the breakout board or IO expansion shield pin mapping. So I need to modify the cable pin mapping. Here's a simple trick to achieve this step by using one jumper cable. Here's a simple step by step tutorial.

1. Insert the jumper cable pin to the jumper house and take the wire out of the pin house.
2. Take out two wires from the jumper house.
3. Plug in the wires to the house according the pin mapping required.

cable pin mapping


That's all. Isn't that easy? ~?~

Related Link: Gravity Sensor
Recent Blogs
  • Tutorial of Run Qwen2.5 Small Language Model on Raspberry Pi 5 using Ollama
    Run Qwen2.5 on Raspberry Pi 5 using Ollama

    This article will explore how to install and run Qwen2.5 on a Raspberry Pi 5 using the Ollama runtime framework.

    REVIEWS Raspberry Pi
    Dec 11 2024
  • Running Gemma2 AI Model on a Raspberry Pi 5 using the Ollama
    Run Gemma2 on Raspberry Pi 5 using Ollama

    In this article, we will delve into the process of installing and running the SLM(small language model) Gemma2 on the Single Board Computer (SBC) Raspberry Pi 5 using the Ollama runtime framework.

    REVIEWS Raspberry Pi
    Dec 11 2024
  • Tutorial and Test of Run phi3.5 Small Language Model on Raspberry Pi 5 Single Board Computer using Ollama
    Run phi3.5 on Raspberry Pi 5 using Ollama

    In this write-up, we delve into the process of installing and executing phi3.5-3.8b on a Raspberry Pi 5, leveraging the Ollama runtime framework.

    REVIEWS Raspberry Pi
    Dec 09 2024