Forum >Compiled OBD data logger sketch too big for Arduino Nano
Compiled OBD data logger sketch too big for Arduino Nano
LogicalUnit 2013-11-13 03:18:04 5783 Views3 Replies Hi again, I just got my [b]Arduino OBD-II Logger Kit #1[/b] delivered today, but when I used the Arduino IDE to upload the obdlogger sketch, it said it was too big. I tried using Arduino Builder, but that fails too. My kit came with a NANO. Is there something I'm doing wrong?
2013-11-13 22:41:03 Okay, I just got my kit working, and have logged my first drive.
However, when I try to display my data on the online chart, it just says "XXXX is not available in this record" for ALL data types. It doesn't display anything at all.
I have attached the log. LogicalUnit
However, when I try to display my data on the online chart, it just says "XXXX is not available in this record" for ALL data types. It doesn't display anything at all.
I have attached the log.
LogicalUnit 2013-11-13 03:49:06 Yes, I downloaded ArduinoOBD-master.zip today. I decompressed, then copied the libraries to the correct folder and opened obdlogger.ino in Arduino IDE. LogicalUnit
LogicalUnit 