Maqueen Plus read wheel revolutions
![userHead](https://dfimg.dfrobot.com/dfPortrait2.png)
HI.
I am trying to understand how to use the Get revolutions of Wheel block in Maqueen Plus.
I have a OLED connected (working properly) where I am trying to see the number of wheel rotations but it always shows 0.
Attached is a picture of the Makecode i'm trying.
Button A should show the wheel revolutions on the OLED (always shows 0)
Button B runs the wheel for 1 second
Button A+B Clears the OLED and the wheel revolutions
I am trying to understand how to use the Get revolutions of Wheel block in Maqueen Plus.
I have a OLED connected (working properly) where I am trying to see the number of wheel rotations but it always shows 0.
Attached is a picture of the Makecode i'm trying.
Button A should show the wheel revolutions on the OLED (always shows 0)
Button B runs the wheel for 1 second
Button A+B Clears the OLED and the wheel revolutions
![icon](images/icon_file.png)
2021-01-14 11:08:57 It is possible that the version of the firmware you are using is too low. Can you blacken the version number of the firmware you are using?
347945801
![userHeadPic](https://dfimg.dfrobot.com/dfPortrait2.png)