-
You Reply: Ok. So should I be powering the board through the DC power jack or M_Vin by the motor pins and then jumping VIN=M_VIN if I want it to move around away from the computer?
-
You Reply: Ok. So should I be powering the board through the DC power jack or M_Vin by the motor pins and then jumping VIN=M_VIN if I want it to move around away from the computer?
-
You Reply: Heres what it looks like after pressing the verify button
-
You Reply: Heres what it looks like after pressing the verify button
-
You Reply: It still doesn;t work. I used the code give by Admin at https://www.dfrobot.com/forum/index.php?topic=60.0 and pressed the verify button in the Arduino software, and it just went to Done compiling. It didn't do anything.
-
You Reply: It still doesn;t work. I used the code give by Admin at https://www.dfrobot.com/forum/index.php?topic=60.0 and pressed the verify button in the Arduino software, and it just went to Done compiling. It didn't do anything.
-
You Reply: There aren't any error codes. when I press the play button, it goes from compiling to done compiling. There might not be any problems with it at all, im just not too sure how to use it.
-
You Reply: There aren't any error codes. when I press the play button, it goes from compiling to done compiling. There might not be any problems with it at all, im just not too sure how to use it.
-
You Reply: It doesn't appear to be.
-
You Reply: It doesn't appear to be.
-
You Reply: I just got my DFRobot 4wd mobile platform put together today. I have the arduino board set as "arduino duemilanove or nano w/atmega 328". When I try sending the blink example sketch to it, it doesn't seem like it did anything. The romeo board still has the pwr light on and the L light blinks. the program just says Done compiling. It is set to send to COM3, but the robot does nothing different compared to when it is just powered on.