Forum >Replies by weisheil
Replies （3）
- You Reply: We've tried that in re-configuring but I'm not trying to re-configure the shield, I want to control my robot and send characters to it via wifi.
If there is a particular way on how to do this then please let me know. Your help is really appreciated. Thank you! - You Reply: Yeah you're definitely right about WizSmart! When I tried configuring the shield using my laptop it does not work in Putty but when I used other computer it works just fine.
Now I'm able to see the shield connected to my router. However it is not recorded in DHCP though I set AT+NDHCP = 1.
My problem now is that, I can't communicate with my shield through wifi even though I set the switch to Wifi and Run mode. I used Putty to send data "0" and "1" which is needed in the program I loaded the shield with. I setup the putty in RAW and 5000 port number(which is the same as what I configured it).
When I used serial connection to send data using the arduino sketch Serial Monitor and Putty they both work great.
What should I do to send data to shield? Thank you! - You Reply: Hello,
I'm using WizSmartScript and during the configuration I encountered ATC1, AT&W0 and ATA and there'll all [OK]. When I tried removing the supply, and replug it only the POWER led remains lit and it does not connected to the router anymore.
I also tried using putty after that and this message is displayed: "[UnExpected Warm Boot(Possibly Low Battery)]". Does it affect the functionality of the shield? What do I do with it? Your help would really help a lot. Thanks!