Hi, I am using this pressure sensor and Arduino library.

I would like to know what does ambient air pressure calibration do. It is possible to enable and disable when reading pressure value.

Is it a periodic air pressure calibration? Which value is used to calibrate?

*Get the ambient air pressure. Can set whether to enable calibration.

*1：Enable calibration

*0：Not */

Serial.print(mpx5700.getPressureValue_kpa(1));

on the library DFRobot_MPX5700.cpp I see that register 0x09 is written to 1 if calibration is enabled.

float DFRobot_MPX5700::getPressureValue_kpa(uint8_t ifcalibration)
{
uint8_t buf[2];
float voltage, Pressure;
writeReg(0x09, &ifcalibration, 1);
delay(100);
readReg(0x06, buf,2);
uint16_t Pressure_100 = ((uint16_t)buf[0] << 8) | (uint16_t)buf[1];
return (Pressure_100/100.0);
}

Thanks