HOME COMMUNITY FORUM WIKI BLOG LEARN
Forum >Replies by anonymous
userhead anonymous
Replies （11）
  • Topic: WIFIbee MT7681 PB
    You Reply: Not serious !! I regret my purchases...
  • Topic: WIFIbee MT7681 PB
    You Reply: Not serious !! I regret my purchases...
  • Topic: WIFIbee MT7681 PB
    You Reply: Up :(
  • Topic: WIFIbee MT7681 PB
    You Reply: Up :(
  • Topic: WIFIbee MT7681 PB
    You Reply: Hi,
    No new information about a firmware update ? I can be a beta tester if needed
    Thanks
  • Topic: WIFIbee MT7681 PB
    You Reply: Hi,
    No new information about a firmware update ? I can be a beta tester if needed
    Thanks
  • Topic: WIFIbee MT7681 PB
    You Reply: Hi,

    Thank you for your answer.
    However, I tried with my mobilephone too which was very close to the module (few centimeters).
    When the module is in AP mode, i can see the network.

    In STM mode, i have SM=2, Sub=0, so the module tries to connect to the network according to the machine state in the datasheet but it returns to initialization mode and switches to smart link. I tried with different authentifications too without success.
    A scan AT command should be interesting to debug.
  • Topic: WIFIbee MT7681 PB
    You Reply: Hi,

    Thank you for your answer.
    However, I tried with my mobilephone too which was very close to the module (few centimeters).
    When the module is in AP mode, i can see the network.

    In STM mode, i have SM=2, Sub=0, so the module tries to connect to the network according to the machine state in the datasheet but it returns to initialization mode and switches to smart link. I tried with different authentifications too without success.
    A scan AT command should be interesting to debug.
  • Topic: WIFIbee MT7681 PB
    You Reply: Hi,

    With SmartLink, same problem...
    waiting for smartlink...
    SM=1, Sub=0
    SM=0, Sub=0
    waiting for smartlink...
    SM=1, Sub=0
  • Topic: WIFIbee MT7681 PB
    You Reply: Hi,

    With SmartLink, same problem...
    waiting for smartlink...
    SM=1, Sub=0
    SM=0, Sub=0
    waiting for smartlink...
    SM=1, Sub=0
  • Topic: WIFIbee MT7681 PB
    You Reply: Hi,

    It's not possible to connect the module to a network following these instructions : Configure the wireless network parameters via AT command
    I also try to create a wireless network called ouki as the example with the same password... but no result.

    I don't understand :|

    Thanks for your help!