Forum >Replies by muhammadarsyil21
Replies （10）
- You Reply: Alhamdulillah it was successful, when my server username and password were disabled, SIM7000C successfully connected.
Thank you for Ms. Nana - You Reply: Alhamdulillah it was successful, when my server username and password were disabled, SIM7000C successfully connected.
Thank you for Ms. Nana - You Reply: Here goes the AT Command listing:
OK
AT+SMCONF="CLIENTID","212"
OK
AT+SMCONF="URL",147.xxx.xxx.50:1883
OK
AT+SMCONF="KEEPTIME",60
OK
AT+SMCONF="CLEANSS",1
OK
AT+SMCONF="USERNAME","sensor"
OK
AT+SMCONF="PASSWORD",hxxxxxxxxxxxxxxQ
OK
AT+SMCONF="QOS",0
OK
AT+SMCONF="TOPIC","sensors"
OK
AT+SMCONF?
+SMCONF
CLIENTID: "212"
URL: 147.xxx.xxx.50:1883
KEEPTIME: 60
USERNAME: "sensor"
PASSWORD: "hxxxxxxxxxxxxxxQ"
CLEANSS: 1
QOS: 0
TOPIC: "sensors"
MESSAGE: ""
RETAIN: 0
OK
AT+SMCONN
ERROR - You Reply: Here goes the AT Command listing:
OK
AT+SMCONF="CLIENTID","212"
OK
AT+SMCONF="URL",147.xxx.xxx.50:1883
OK
AT+SMCONF="KEEPTIME",60
OK
AT+SMCONF="CLEANSS",1
OK
AT+SMCONF="USERNAME","sensor"
OK
AT+SMCONF="PASSWORD",hxxxxxxxxxxxxxxQ
OK
AT+SMCONF="QOS",0
OK
AT+SMCONF="TOPIC","sensors"
OK
AT+SMCONF?
+SMCONF
CLIENTID: "212"
URL: 147.xxx.xxx.50:1883
KEEPTIME: 60
USERNAME: "sensor"
PASSWORD: "hxxxxxxxxxxxxxxQ"
CLEANSS: 1
QOS: 0
TOPIC: "sensors"
MESSAGE: ""
RETAIN: 0
OK
AT+SMCONN
ERROR - You Reply: I have adjusted the parameters according to the server, but still cannot connect to the server, the information here I am using the VERNEMQ server (for the MQTT server).
When I tried the SIM7000C module to connect to the local or other server that I made myself it was successful - You Reply: I have adjusted the parameters according to the server, but still cannot connect to the server, the information here I am using the VERNEMQ server (for the MQTT server).
When I tried the SIM7000C module to connect to the local or other server that I made myself it was successful - You Reply: Do all parameters in AT + SMCONF have to be set or only some of them like (URL, USERNAME, PASSWORD)?
- You Reply: Do all parameters in AT + SMCONF have to be set or only some of them like (URL, USERNAME, PASSWORD)?
- You Reply: I want to ask, I also encountered problems when running the AT-SMCONN command for the 7000C SIM module.
Can anyone give me a solution?
Thank you - You Reply: I want to ask, I also encountered problems when running the AT-SMCONN command for the 7000C SIM module.
Can anyone give me a solution?
Thank you