HOME COMMUNITY FORUM WIKI BLOG LEARN
Forum >Replies by Private Ltd Implantaire Technologies (I)
userhead Private Ltd Implantaire Technologies (I)
Replies （14）
  • Topic:
    You Reply: Haha :lol:
  • Topic: DFR0030 EC meter
    You Reply: How did you calculate the calibration range i.e. (factorTemp>0.55) && (factorTemp<1.45)?
  • Topic: DFR0030 EC meter
    You Reply: How did you calculate the calibration range i.e. (factorTemp>0.55) && (factorTemp<1.45)?
  • Topic: DFR0030 EC meter
    You Reply: Thank you:) it worked.
  • Topic: DFR0030 EC meter
    You Reply: Thank you:) it worked.
  • Topic: DFR0030 EC meter
    You Reply: Hi, I was able to run the meter.

    But, need to calibrate! the values are 10 to 11 ms/cm for the 12.88 ms/cm solution & 1.07 ms/cm for 1.41 ms/cm solution.

    I tried to calibrate it with the Calibration code from the "github" but when i send "confirm" from the serial monitor it displays "Confirm Failed,Try Again". Any suggestions?
  • Topic: DFR0030 EC meter
    You Reply: Hi, I was able to run the meter.

    But, need to calibrate! the values are 10 to 11 ms/cm for the 12.88 ms/cm solution & 1.07 ms/cm for 1.41 ms/cm solution.

    I tried to calibrate it with the Calibration code from the "github" but when i send "confirm" from the serial monitor it displays "Confirm Failed,Try Again". Any suggestions?
  • Topic: DFR0030 EC meter
    You Reply: Should the baud rate be 115200? can't i use 9600 baud rate?
  • Topic: DFR0030 EC meter
    You Reply: Should the baud rate be 115200? can't i use 9600 baud rate?
  • Topic: DFR0030 EC meter
    You Reply: Yeah. If i run only the Water temperature code then it works fine. but if i connect the EC sensor along with the temperature probe as mentioned in the DFROBOT wiki it will Display some random unreadable text.
  • Topic: DFR0030 EC meter
    You Reply: Yeah. If i run only the Water temperature code then it works fine. but if i connect the EC sensor along with the temperature probe as mentioned in the DFROBOT wiki it will Display some random unreadable text.
  • Topic: DFR0030 EC meter
    You Reply: Hi, I'm getting garbage value in the serial monitor when i run the sample code of the DFR0300 EC meter. the interfacing is as per the instruction given in wiki. Need help!!!!
  • Topic: Analog CO2 Gas Sensor
    You Reply: What is the sensitivity of this sensor? in ppm
  • Topic: Light Sensors
    You Reply: Thank you for the reply :) LUX is the unit of luminance flux of light.