Hello,

I am using the sim7600CE shield and an Arduino uno WIFI rev2.

However I can not get the device to work, I tried to set it up using the manual on: https://wiki.dfrobot.com/SIM7600CE-T_4G(LTE)_Shield_V1.0_SKU_TEL0124

I use my (Dutch) sim card that works fine on my phone and has the SIM pin disabled. After inserting the sim in the shield, put it on the arduino and connect to power source and then pressing ‘BOOT’ as instructed does not give the result as expected, I tried many times and usually the ‘NET’ light does not light up at all. 2 times it did blink once, however it should continue blinking every second to indicate the network is connected.

Also when uploading the code and sending AT in the serial monitor on the correct baud rate, I do not get any response at all. whereas serial monitor works for me using other scripts with my arduino.

Does anybody know what's wrong and how i can get the shield to work?

Thanks in advance