Hi everyone,

I am currently playing around with the Maqueen Plus V2 and the Mechanic Set. I am trying to connect a servo motor to the Maqueen, but I can't get it to actually do something.

Firstly, I cannot find a servo “block” command in the Maqueen Plus V2 extension on Makecode. There is one in the “normal” maqueen extension and one in the maqueen plus extension, but not in the v2 one. Using the Maqueen Plus extension did not work, the servo motor does not move at all…

So I tried a more low level approach and sent the corresponding bytes directly via i2c (address 0x10, followed by 0x14 for the first servo port and the angle to turn to) in micropython. That too does nothing, however. On the maqueen, this approach works fine.

I also noticed that on the V2 model, the Servo Ports are labelled with VBAT instead of VCC (in the older models), maybe that has something to do with it?

I would really appreciate any hints or tips on how to get the servo motors to work with the Maqueen Plus V2.

Thanks in Advance!