Hello!

I'm succesfully connecting Wind Speed sensor to ESP32 using simple TTL-RS485 converter, without issues.

After that, I tried to change the ADDRESS of the Wind Direction sensor SEN0482, and it stopped to answer.

I'm trying to debug the issue, and I think the easiest way would be to read the ADDRESS REGISTER (0x10 0x00) using the broadcast station number (0x00) to check the register content (because I do not know the actually stored station number) having only Wind Direction sensor connented to the RS485 bus.

Unfortunately, I cannot get any answer.

This is the inquiry frame I'm using (8 bytes):

0x00 0x03 0x10 0x00 0x00 0x01 0x81 0x1B

where:

0x00 0x03 = Broadcast station number + read function code

0x10 0x00 = ADDRESS REGISTER

0x00 0x01 = Register lenght

0x81 0x1B = CRC-16 according to MODBUS (see https://crccalc.com/)

and I expect to read:

0x0# 0x03 0x10 0x00 0x00 0x0# CRCHigh CRCLow

where:

0x0# 0x03 = Receiving station + read function code

0x10 0x00 = ADDRESS REGISTER

0x00 0x0# = stored station number

CRCHigh CRCLOw = related CRC bytes

What is wrong with this?

Is there any command to force a “factory reset”?

Here is my code,

thanks for help!

#define RS485_PIN_DIR 5 // TTL-to-RS485 command pin

#define RXD2 16

#define TXD2 17

#define RS485_WRITE 1

#define RS485_READ 0

byte leggi_frame[] = {0x00, 0x03, 0x10, 0x00, 0x00, 0x01, 0x81, 0x1B};

byte buf_addr[8];

void setup()

{

Serial.begin(115200);

delay(3000);

Serial.println("");

Serial.println("=========================================");

Serial.println("");

Serial2.begin(9600, SERIAL_8N1, RXD2, TXD2);

pinMode(RS485_PIN_DIR,OUTPUT);

digitalWrite(RS485_PIN_DIR,RS485_READ);

delay(1000);

digitalWrite(RS485_PIN_DIR,RS485_WRITE);

Serial.println("Send inquiry");

Serial2.write(leggi_frame, 8);

delay(10);

// Reading answer

digitalWrite(RS485_PIN_DIR,RS485_READ);

Serial2.readBytes(buf_addr, 8);

delay(1000);

Serial.println("");

Serial.print(buf_addr[0], HEX);

Serial.print(" ");

Serial.print(buf_addr[1], HEX);

Serial.print(" ");

Serial.print(buf_addr[2], HEX);

Serial.print(" ");

Serial.print(buf_addr[3], HEX);

Serial.print(" ");

Serial.print(buf_addr[4], HEX);

Serial.print(" ");

Serial.print(buf_addr[5], HEX);

Serial.print(" ");

Serial.print(buf_addr[6], HEX);

Serial.print(" ");

Serial.println(buf_addr[7], HEX);

}

void loop()

{ // do nothing

}