Sorry for inconveneience, problem fixed, this was due to the USB -C cable, power cable only…

May be this is good to know for newbies  to double check cables!!!!!

I also tried on IDE1.8.19 ( installed from scratch). With this IDE the status at the bottom  says  COM1 disabled…

Hello 

I use the DFR1117 beetle ESP32-C6  arduino IDE2.3.2  board manager ESP32 3.0.0rc3

Withe same code from above,

I did follow all steps given here for first time use

 https://wiki.dfrobot.com/SKU_DFR1117_Beetle_

ESP32_C6#target_7
I get this msg: A fatal error occurred: Failed to connect to ESP32-C6: No serial data received.

after hold down boot button and press reset , upload, then  I push reset again, the led is blinking, ( code uploaded) but the port COM1 is still unavailable…

OS : Windows10 pro.

Any suggestions to recover serial monitor?